New Project – Organic Poultry Unit - Our mission to rear poultry to the highest standards

Poultry Paddock is establishing organic poultry production at new House Farm in Acton. Organic poultry production requires the highest standard of animal welfare, these are the main differences compared with conventional free range rearing:

  • Smaller flocks
  • Use of slower growing breeds
  • GM free diet
  • More space in the houses
  • More space on the range
  • No routine use of antibiotics
  • No mutilations such as beak trimming
  • Regular rotation of pasture to allow recovery and prevent the build up of parasites and nitrogen in the soil

This page diaries our progress.

Step 1. Find suitable land.

Organic Land

Organic Land

This is where we will set up, south facing well drained, organic certified land at New House Farm in Acton.

Step 2 – Build the first poultry unit

To enable rotation of pasture the poultry sheds must be mobile, we decided to self build our own polytunnel type units to our own design using as many recycled components as we could.

The mobile unit needed to be insulated, not just to keep the chickens warm in the cold winter weather, but to ensure that condensation did not form on the inside and create a rainforest type micro-climate inside and to insulate it from the summer sun, so that the birds do not overheat.

First we made the frame, using second hand scaffold tube, fastened together with Key Clamps and forged scaffold fittings. for the hoops I used recycled 62mm MDPE gas pipe, which is exactly the right size to slide over the scaffold tube.

The bare frame

The bare frame

20170207_125047

The side panels, end panels and doors are made from fibreglass skinned polyurethane foam. Once again this is recycled, the panels came from a door manufacturer, they are the window cutouts from exterior doors glued together using polyurethane glue. The panels would otherwise have gone to landfill if not reused for this project. I must give great thanks to Paul Ridley for developing reuse of these panels for shelter construction. The panels I chose are discrete brown,black and green on the outside and white on the inside to reflect the light.

The panels are clamped to the frame using limpet clamps (usualy used to clamp scaffold boards to tube) and builders restraint straps.

20170207_125106 20170215_124419 20170215_124537

The roof has 3 layers, on the inside is a sheet of Mushroom cover polythene, this is a triple layer black-out material, white on the inside to reflect the light and green on the outside. The middle layer is 100mm fibreglass insulation which sits in layflat polythene tubing to keep it in place, the top layer is another layer of mushroom cover, with the discrete green colour on the outside.

20170323_152702 20170323_152721

All 3 layers of the roof are clipped onto the scaffold tube side rails using omega clips, these are usually used to fasten shrink wrap sheeting to  scaffolding. They are expensive for what they are, but do the job perfectly.

20170402_131128

The shed will need to be moved onto new pasture every 3 months, so as soon as the frame and first layer of the roof were built, we put some wheels under it, hooked it up to the tractor and took it for a short test drive, just the make sure everything was strong enough to withstand a move. Much to my surprise nothing broke.

The insulation is added.

20170402_131116

And then the top cover.

20170402_173736

 

Step 3 – Add the interior fittings

Brooder Heater

The broilers will spend their whole life in the same poultry house so that they don’t get stressed by being rehoused, this is best for the their health. For the first 4 weeks they will stay indoors under a heat lamp and the temperature will be gradually reduced and by 4 weeks they’ll have daytime access to the outdoor range.

We will use a thermostatically controlled Propane powered infrared spot heater to keep them warm.

Lighting

The chicks will perform best if they have long hours of light over the first few days, so we fitted a solar powered LED lamp.

Feeders

The chicks eat crumb off the floor for the first 3 days but after that they’ll eat from the tube feeders suspended from the ceiling.

Drinkers

The Chickens will drink from suspended nipple lines which are raised as the chickens grow. These drinkers are designed so that the birds cannot perch on them, and to swing about a bit to keep the chickens entertained.

The drinkers are automatically filled from an elevated tank outside the house.

Perches and Straw Bales.

The birds like to climb onto things, so perches and a few straw bales help to occupy them so that they are less likely to peck one another. the straw bales also give them something to nibble at occasionally.

Bedding

The floor of the house is covered with a layer of chopped straw. we used a combination of wheat straw and Miscanthus grass straw.

Fence the Range

The free range outdoor area needs to be secure, to keep the chickens in and the predators out. We need to move the poultry unit onto new pasture every 3 months, so we used electrified Flexi-net which is easy to move. The energiser is powered by a solar charged battery.